Epson Stylus Pro 9500 - Page 188

EPSON Stylus Pro 9500 Revision A
Adjustment Adjustment Steps 188
COUNTER CLEAR
This function resets (to the original condition) the following counters which are
stored in memory on the Main Board.
Note *: "1" means the flag is set, and the next time power is turned on the printer will
perform an initial ink charge.
Table 5-9. Counters Reset by "Counter Clear"
Counter Reset Value
Protection Counter A/B 0
Ink Volume Counter Rb/ Ry/ Rx Rz 0
Consumed Ink Counter Cb/ Cy/ Cm/ Cc/ Cml/ Ccl 0
Power Cutoff Timer T2 0
Accumulated Prints Timer 0
CL Timer 0
CL Timer 3 0
CL Flag 0
Initial Charge Flag 1*
Periodic Pseudo-Vacuum Flag 0
CAUTION
Since the counter for the remaining ink holding
capacity of the waste ink pads and the ink
consumption counter, etc. are cleared by this
function, if the counters have been cleared, all the
affected parts (waste ink pads, ink cartridges) should
be replaced with new ones.