Epson Stylus Pro 9500 - Page 186

EPSON Stylus Pro 9500 Revision A
Adjustment Adjustment Steps 186
TEST PATTERN PRINT
This function prints a test pattern plus certain printer information/settings that
you can refer to when performing printer adjustment procedures. For a list of
the information that is printed, see the following table.
To print the list of variable items you need to enter the printer’s serial number
when prompted. The serial number is located on the back of the printer, next to
the power connector.
CLEAN HEAD (DRAIN INK)
This function allows you to drain the ink from the ink delivery system including
the printheads. Perform the Clean Head function before moving the printer.
Table 5-8. Printed Items in the Test Pattern
Item Description
Nozzle Check Prints all of the check/test patterns that are available from
the "Adjustment" menu.
Adjustment Variables Prints a list of all the adjustable items from the
"Adjustment" menu.
Print: Nozzle Check
[Enter]
[Enter]
[SelecType]/
[Item]
[SelecType]/
[Item]
The printer prints the adjustment-
parameter list, ejects the paper, and
proceeds to next menu.
End
adjustment/
next menu
Printing Pattern
Printing Pattern
Print: Adj. Variable
No. X: PEG
* * * * * * * *
Print Adj. Pattern
Paper Feed [+] or [-]
X = "1"~"4"
*
= Serial number
[Enter]
[Enter]
Adj Clean Head
Please Remove Ink
Please Lower InkLever
Please Remove Ink
Cleaning
Set Cleaning tool
Press the Pause button
to quit this menu and
complete this operation.
[Pause]
Not applicable for
service purposes
Remove all ink cartridges.
Lower both ink set levers.
Perform ink drain operation.