c
Important:
If the right holder handle shaft is not visible,
rotate the holder forward until it stops. The
media can not be properly loaded if the handle
shaft is not visible.
C
Temporarily place media on the roll supports
oriented according to how it is rolled (see below)
Printable Side Out
Printable Side In
Note:
Be sure the option selected for Roll Type in the
Customize Settings menu matches how the media
is rolled. Roll Type defaults to Printable Side Out.
Be sure to select Printable Side In after loading
media rolled printable side in.
For more information see U “Roll Type” on
page 65
D
Place the left edge of the media in any of the black
squares in the label on the bar on the near side of
the back of the printer and the right edge on any
of the holes on the back of the printer.
The recommended positions for media of
different widths are shown below.
U “Positioning Media of Different Widths” on
page 70
Note:
If the label with black squares is not in place, affix
the label as described in the Setup Guide.
U Setup Guide
E
Raise the lift lever on the left side of the printer to
lift the media into position, then firmly insert the
roll holder.
If the roll of media has the outer diameter which
is less than 140mm, lift it up by your hands, and
set it to the roll holder. The roll core will not reach
the holder when raised using the lift lever.
EPSON SC-S70600 series/SC-S50600 series/SC-S30600 series User's Guide
Basic Operations
33
To Next Page
Loading...
