F
Tighten the roll holder screw to fix the roll holder
in place.
G
Raise the lift lever on the right side of the printer
to lift the media into position, then firmly insert
the roll holder.
If the roll of media has the outer diameter which
is less than 140mm, lift it up by your hands, and
set it to the roll holder as described in Step 5.
H
Tighten the roll holder screw to fix the roll holder
in place.
I
Rotate the handle until part A in the illustration
below is fully inserted.
c
Important:
Once part A is hidden, do not turn the handle
any further. Failure to observe this precaution
could damage the roll holder.
EPSON SC-S70600 series/SC-S50600 series/SC-S30600 series User's Guide
Basic Operations
34
To Next Page
Loading...
