J
Raise the media loading lever.
K
Pull out the media and insert it into the printer.
Note:
Media that is heavy and difficult to unroll can be
fed by pressing the drive switch on the left roll
holder.
Printable Side Out
Printable Side In
L
Insert the media past the pressure rollers and
lower the media loading lever to hold it in place.
M
Go to the front of the printer and open the front
cover.
N
Hold the center of the media and raise the media
loading lever.
O
Pull the media straight forward until the edge has
past the label on the left side of the after heater.
Keep the right edge of the media parallel with the
scale markings on the two labels on the right side
of the after heater.
c
Important:
Perform Steps 14 to 3 in reverse order and
repeat the loading process if the right edge of
the media is not within the scale markings. Do
not attempt to reposition the roll holders
while they are inserted in the media.
EPSON SC-S70600 series/SC-S50600 series/SC-S30600 series User's Guide
Basic Operations
35
To Next Page
Loading...
