c
Important:
❏ Do not use the media holding plates with
media that is more than 0.4 mm thick.
The media holding plates could touch
and damage the print head.
❏ Move the media holding plates to the left
and right edges of the platen when they
are not in use.
❏ Do not use the media holding plates if the
sides of the printed media are smudged or
torn.
❏ Leave left and right margins of over 10
mm when using the media holding
plates. Narrower margins could result in
printer printing over the plates.
Q
Close the front cover.
Using the Optional Heavy Roll Media
Feeding Unit
This section describes how to load media when the
optional heavy roll media feeding unit is installed.
Using a lifter is recommended when handling a media
that is 40 kg or heavier.
The explanation that follows assumes that a lifter is
used.
The following types of lifter can be used.
❏ Fork or platform thickness: 28 mm or less
❏ Fork or platform can be lowered to approx.190mm
from the floor.
!
Caution:
Because the media is heavy, it should not be carried
by one person. When loading or removing the
media, use at least two persons. Using a lifter is
recommended when handling a media that is 40 kg
or heavier.
A
Turn on the printer by pressing the P button.
B
Loosen the roll holder fixing screws and adjust
the roll holders so that the gap between the two is
wider than the media.
c
Important:
If the right holder handle shaft is not visible,
rotate the holder forward until it stops. The
media can not be properly loaded if the handle
shaft is not visible.
C
Place the media on a lifter oriented according to
how it is rolled (see below) and move the lift to
position the media as indicated by the mark on
the label.
Printable Side Out
EPSON SC-S70600 series/SC-S50600 series/SC-S30600 series User's Guide
Basic Operations
48
To Next Page
Loading...
