Epson SureColor SC-T7700D - Performing the Connection Test; Initializing the Network Settings

❏ pathping command
You can conrm the list of routers passing through the destination host and the routing of communication.
❏ Format : pathping xxx.xxx.xxx.xxx
❏ Examples : pathping 192.0.2.222
Performing the Connection Test
From the printer or the computer connected to the same segment as the printer, check whether the connection
with the server and folder is correct. is will lead you to solve the problems.
Mail Server
Check the connection between the printer and the mail server by using the connection test function of the printer.
Related Information
& “Checking a Mail Server Connection” on page 31
DNS Server
Check the DNS server that is referred by the computer. Conrm the status of the network adapter of the computer
on the same network segment as the printer, and
conrm
whether it is the same as the DNS setting of the printer.
You can check the DNS setting of the computer as follows.
❏ Wi n d ow s : Control Panel > Network and Internet > Network and Sharing Center > Change adapter settings
When there are multiple network interfaces, you can check by entering “ipcong/all” on the command prompt.
❏ Mac OS : System Preference > Network > Advanced... > DNS
Initializing the Network Settings
Disabling Wi-Fi from Web
Cong
Disable Wi-Fi from Web Cong. If you disable Wi-Fi while some devices are connected by Wi-Fi, they are
disconnected.
Administrator's Guide
Solving Problems
63