Epson SureColor SC-T7700D

Changing from Wi-Fi Connection to Ethernet Connection
Changing the Network Connection to Ethernet from the Control Panel
Follow the steps below to change the network connection to Ethernet from Wi-Fi using the control panel.
1. Select Menu on the home screen.
2. Select General Settings > Network Settings > Wi r e d L A N S e t u p .
3. Tap Start Setup.
4. Check the message, and then close the screen.
e screen automatically closes aer a specic length of time.
5. Connect the printer to a router using an Ethernet cable.
Related Information
& “Connecting to Ethernet” on page 21
Changing to Ethernet Connection Using Web Cong
Change the Wi-Fi connection to Ethernet connection by using Web
Cong
.
1. Access Web Cong and select the Network tab > Wi - F i .
2. Click Disable Wi-Fi.
3. Check the message, and then select OK.
4. Connect the printer and hub (LAN switch) by Ethernet cable.
Note:
You can also change the connection method by using Epson Device Admin. For details, see the guide or help for Epson
Device Admin.
Related Information
& “Accessing Web Cong” on page 24
& “Logging on to the Printer Using Web Cong” on page 48
& “Epson Device Admin” on page 68
Using Port for the Printer
e printer uses the following port. ese ports should be allowed to become available by the network
administrator as necessary.
Administrator's Guide
Appendix
74