Epson SureColor SC-T7700D

2. Select Wi - Fi D i r e c t .
e Wi-Fi Direct information is displayed.
3. Tap Start Setup.
4.
Tap Change Settings.
5. Select Disable Wi-Fi Direct.
6. Tap the Disable the settings.
7. When a completion message is displayed, close the screen.
e screen automatically closes aer a specic length of time.
Restoring the Network Settings from the Control Panel
You can restore all network settings to their defaults.
1. Select Menu on the home screen.
2. Select General Settings >System Administration >Restore Default Settings > Network Settings.
3. Check the message, and then select Ye s .
4. When a completion message is displayed, close the screen.
e screen automatically closes aer a specic length of time.
Trouble Case
Cannot Access Web
Cong
The IP address is not assigned to the printer.
A valid IP address may not be assigned to the printer.
Congure
the IP address using the printer’s control panel.
You can conrm the current setting information with a network status sheet or from the printer’s control panel.
Web browser does not support the Encryption Strength for SSL/TLS.
SSL/TLS has the Encryption Strength. Web Cong can be opened by the web browser that supports the bulk
encryptions as follows. Check your browser's encryption support.
❏ 80bit: AES256/AES128/3DES
❏ 112bit: AES256/AES128/3DES
❏ 128bit: AES256/AES128
❏ 192bit: AES256
❏ 256bit: AES256
Administrator's Guide
Solving Problems
65