18
Power Switch
•When DIP switch 1 is OFF, the power is turned on after the POWER button has been pressed
for 3 seconds.
•When DIP switch 1 is ON, the printer settings are reset after POWER button has been pressed
for 3 seconds.
Power Switch Cover
Attaching the power switch cover prevents accidental pressing of the power switch.
∗ To prevent the power switch from being pressed:
Attach the power switch cover as it is (without punching a hole in it).
∗ To prevent the power switch from being pressed unless a long, thin object is pressed into a hole in the
power switch cover:
Attach the power switch cover after punching a hole in it.
CAUTION
Before turning on the printer, be sure to check that the AC adapter is connected to
the power supply.
See "Setting the DIP Switches" on page 76 for DIP switch setting.
For details about attaching the power switch cover, see "Attaching the Power Switch
Cover" on page 100.
Be sure to change the DIP switch setting when you want to attach the power switch cover
without punching a hole in it. (See "Setting the DIP Switches" on page 76.)
WARNING
Make sure to pull out the AC cable if the printer is damaged when attaching the
power switch cover. Using it as it is may cause a fire.
To Next Page
Loading...
Need help?
General