Chapter 4 Handling
189
4
Setting Check Modes
Besides the ordinary print mode, the printer has a self-test mode and allows you to print a status
sheet (Ethernet interface model only) to check the various settings of the printer.
Self-test Mode
Printing errors such as dot missing can be checked in the self-test mode.
Follow the steps below to run the self-test.
1
Set the die-cut label, receipt or continuous label whose length is 90 mm
or more.
2
Turn the power on while pressing the paper feed button. (Keep pressing
the Power switch until the POWER LED is on.)
Following test pattern is printed.
To Next Page
Loading...
