78
Loading/Replacing the Paper
Follow the steps below to load the paper for the first time, change classification or type of the
paper (roll paper or fanfold paper) or replace the paper.
Loading the paper is different depending of the type of the paper to use roll paper or fanfold
paper.
• For roll paper, see Loading/Replacing the Roll Paper on page 78.
•For fanfold paper, see Loading/Replacing Fanfold Paper on page 88.
Loading/Replacing the Roll Paper
Follow the steps below to load the roll paper.
•Loading the paper for the first time: 2 to 5
•Using up the paper completely (loads same type of paper): 1, 5
•Changing paper type or classification: 1 to 5
• Use paper that meets the printer specification. For details about paper specification, see
Printing Specifications on page 29.
• When exchanging paper without changing paper type, media position detection, or
paper width, see Replacing the Paper on page 145.
Before loading or replacing the roll paper, make sure that the DIP switch 3 (paper selection)
setting is OFF (roll paper). See
Setting the DIP Switches on page 76
for DIP switches
settings.
3. Removing the paper feed guide (page 82)
4. Adjusting roll paper guide/paper ejection guide (page 83)
5. Loading the paper and turning on the printer (page 86)
2. Setting for media position detection (page 81)
1. Removing the paper (page 79)
To Next Page
Loading...
Need help?
General