Epson TM-P20 - Epsonnet Config (Web Version); Starting Epsonnet Config (Web Version)

65
Chapter 3 Advanced Usage
3
EpsonNet Config (Web Version)
EpsonNet Config (Web version) is a utility to configure the network and other settings on a web browser.
Starting EpsonNet Config (Web Version)
Follow the steps below to start up EpsonNet Config (web version).
1
Start up a PC connected to the network.
2
Start up the web browser and input the printer’s IP address (http://printer’s IP
address) in the address bar as shown below.
http://xxx.xxx.xxx.xxx
EpsonNet Config starts.
 You can check the printer's IP address from the dynamic status sheet or in self-test mode.
For details on printing the dynamic status sheet, see
"Dynamic Status Sheet Print Mode" on
page 63
. For details on the self-test mode, see "Self-test mode" on page 55.
 In the initial setting, the user name and password will be required on the authentication
screen when you access EpsonNet Config (web version) from a browser. Enter “epson” for
both user name and password. You can change the password in [Password] in the Optional
configuration menu.