79
Chapter 5 Handling
5
Using the battery spacer (OT-BS20)
1
Connect the single charger or quad charger, AC adapter, and the AC cable as shown
in the illustration.
2
Connect the power plug to an electrical outlet.
3
Connect the battery spacer to the single charger or the quad charger.
4
Set the battery.
Charging starts. While charging the Charge LED turns on.
If the Charge LED flashes, this indicates a problem with charging. If it continues to flash even after
reattaching the battery spacer, the battery or the charger may be malfunctioning.
5
When charging is complete, the Charge LED turns off.
6
Remove the battery from the battery spacer.
To Next Page
Loading...
