Epson TM-T81

Confidential
EPSON
TITLE
SHEET
REVISION
NO
SHEETNEXT
4 3
TM-T81
Specification
(STANDARD)
A
1.4 Paper Roll Supply Device
1) Supply method: Drop-in paper roll
2) Roll paper end sensor: Detects whether paper is present or not.
When the sensor detects a paper-end, the printer stops printing.
Printing resumes when paper is installed and the printer cover is
closed.
a) Detection method: Microswitch
NOTE: If paper other than the specified one is used, the paper roll end sensor may
not work correctly.
3) Roll paper near-end sensor: Detects a near-end of a paper roll.
If the sensor is enabled by ESC c 4, the printer stops printing.
a) Detection method: Microswitch
b) Near-end adjustment: Can be adjusted by changing the position of the adjusting screw.
Fixed position #1 (approximately 23 mm {0.9"})
#2 (approximately 27 mm {1.06"})
NOTE: If roll paper whose paper spool is out of the specified range is used, the roll
paper near-end detection may not work correctly.
1.5 Paper Specification
1) Paper type: Specified thermal paper
2) Form and size: Roll paper
a) Roll paper diameter: 83 mm {3.27"} maximum
b) Roll paper spool: Inside: 12 mm {0.47"}
Outside: 18 mm {0.71"}
Width: Same with the paper width or less than the paper width by
1 mm {0.039"}.
NOTE: Paper must not be pasted to the roll paper spool.
c) Take-up roll paper width: 80 +0.5/–1.0 mm {3.15+0.02/–0.04"}
d) Paper width: 79.5 ± 0.5 mm {3.13 ± 0.02"}
3) Specified paper: NTP080-80
[Original paper: TF50KS-E Nippon Paper Industries Co., Ltd.]
In Japan: Nakagawa Manufacturing Co., Ltd.
In U.S.A.: Nakagawa Mfg. (USA) Inc.
In Europe: Nakagawa Mfg. (Europe) GmbH.
In Southeast Asia: N.A.K. Mfg. (Malaysia) SDN. BHD.