TM-T81
Specification
(STANDARD)
DLE DC4 fn d1…d7 (fn = 8)
[Name] Clear buffer(s)
[Format] ASCII DLE DC4 fn d1…d7
Hex 10 14 fn d1…d7
Decimal 16 20 fn d1…d7
[Range] fn = 8
d1 = 1 , d2 = 3 , d3 = 20 , d4 = 1 , d5 = 6 , d6 = 2 , d7 = 8
[Description] • Clears all data stored in the receive buffer and the print buffer and transmits Clear
response.
• If a recoverable error occurs, recovers from the error.
[Notes] • Do not use this command in a system that uses the printer with the OPOS driver or
the JavaPOS driver provided by Seiko Epson Corporation.
• Take the following into consideration:
• If the received data includes a data string matching this command, the printer
performs the command. Users must consider this.
For example: Graphic data might accidentally include a data string matching this
command.
• Do not embed this command within another command.
For example: Graphic data might include this command.
• When this command is transmitted, the data following must not be transmitted until
the status is received.
ESC FF
[Name] Print data in page mode
[Format] ASCII ESC FF
Hex 1B 0C
Decimal 27 12
[Description] • In page mode, prints all the data in the print buffer collectively.
ESC SP n
[Name] Set right-side character spacing
[Format] ASCII ESC SP n
Hex 1B 20 n
Decimal 27 32 n
[Range] 0 ≤ n ≤ 255
[Default] n = 0
[Description] • Sets the right-side character spacing to [n × (horizontal or vertical motion unit)].
[Note] • The maximum is 35.98 mm {255/180"}.
To Next Page
Loading...
