TM-T81
Specification
(STANDARD)
ESC a n
[Name] Select justification
[Format] ASCII ESC a n
Hex 1B 61 n
Decimal 27 97 n
[Range] 0 ≤ n ≤ 2 , 48 ≤ n ≤ 50
[Default] n = 0
[Description] • In standard mode, aligns all the data in one line to the selected layout.
n
Justification
0, 48 Left justification
1, 49 Centering
2, 50 Right justification
ESC c 4 n
[Name] Select paper sensor(s) to stop printing
[Format] ASCII ESC c 4 n
Hex 1B 63 34 n
Decimal 27 99 52 n
[Range] 0 ≤ n ≤ 255
[Default] n = 0
[Description] • Selects the paper sensor(s) to use to stop printing when a paper end is detected.
(n)
Bit Off/On Hex Decimal Function
0 Off 00 0 Roll paper near-end sensor disabled.
On 01 1 Roll paper near-end sensor enabled.
1 Off 00 0 Roll paper near-end sensor disabled.
On 02 2 Roll paper near-end sensor enabled.
2 - 7 Off 00 0 Reserved.
ESC c 5 n
[Name] Enable/disable panel buttons
[Format] ASCII ESC c 5 n
Hex 1B 63 35 n
Decimal 27 99 53 n
[Range] 0 ≤ n ≤ 255
[Default] n = 0
[Description] • Enables or disables the panel buttons.
• When the LSB of n is 0, the panel buttons are enabled.
• When the LSB of n is 1, the panel buttons are disabled.
[Notes] • This command affects the FEED button.
• FEED button is disabled regardless of the settings with this command, when the cover
is open.
To Next Page
Loading...
