Chapter 2 Setup
63
2
1
Turn off the printer.
2
Clean and dry the printer case where the buzzer unit will be installed.
3
With 2 included pieces of the affixing tape combined, peel off the
backing paper on one side, and stick the tape in the center of the
attaching surface of the buzzer unit.
4
Connect the cable of the buzzer unit to the drawer kick-out connector
on the printer.
5
Peel off the backing paper on the other side of the affixing tape, and
attach the buzzer unit to the printer case.
Drawer kick-out
connector
To Next Page
Loading...
