Epson TM-T82II User Manual

Chapter 3 Application Development Information
79
3
When the printer finishes printing the printer status, the following message is printed and
the Paper LED flashes. (The printer is now in the self-test wait mode.):
“Select Modes by pressing Feed button.
Continue SELF-TEST: Less than 1 second
Mode Selection: 1 second or more”
3
Press the Feed button to start the test print (less than 1 second).
The printer starts test printing. (A rolling pattern is printed using on ly the resident
character set.)
After the test printing has finished, the printer prints the following message, and then the
printer is initialized and returned to the normal mode.
“*** completed***”
If you select “Mode Selection,” the printer goes to "NV Graphics Information Print Mode"
(page 81)
, "Receipt Enhancement Information Print Mode" (page 83), or "Memory Switch
Setting Mode" (page 84).

Epson TM-T82II Specifications

General

Print Method	Thermal line printing
Print Speed	200 mm / sec
Auto Cutter	Yes
Paper Width	58 mm
Interfaces	USB, Serial, Ethernet