Epson TM T88V - Page 61

Chapter 2 Setup
61
2
Connecting the Ethernet interface cable
Connect a 10/100BASE-T cable to the 10/100BASE-T LAN connector by pressing firmly until the
connector clicks into place.
CAUTION
• When LAN cables are installed outdoors, make sure devices without proper surge
protection are cushioned by being connected through devices that do have surge
protection.
Otherwise, the devices can be damaged by lightning.
• Never attempt to connect the customer display cable, drawer kick-out cable, or
the standard telephone line cable to the 10/100BASE-T LAN connector.
When using the Ethernet interface, the network configuration is required. Make the settings
using TM-T88V Utility.
016(146'.'%1//70+%#6+1075'
-'+06'.'(10#05%*.755/
10/100BASE-T LAN
interface connector
LED
(Green)
LED
(Yellow)
Switch
Press down the switch for a
while when the power is on to
initialize to the factory settings.