96
Printable Area (for 80 mm Width Paper)
The printable area (left/right margins, print start position from the autocutting position, print
start position from the manual cutting position) of the TM-T88V is the same as that of the
TM-T88IV.
Cutting Method
The TM-T88V uses the partial cutting method (cutting with one point in left edge left uncut) as
does the TM-T88IV.
Manual Paper Feed
Manual paper feed is not possible with the TM-T88V while it is possible with the TM-T88IV after
printing pauses.
Receive Buffer
You can set the receive buffer of the TM-T88V to 4KB or 45 bytes with DIP switch 1-2 as with the
TM-T88IV. The buffer full condition and buffer full release condition of the TM-T88V are the
same as those of the TM-T88IV.
Memory Capacity
The sizes of the download buffer and NV graphics data of the TM-T88V are the same as those of
the TM-T88IV.
Electrical Characteristics
The operating voltage of the TM-T88V is DC24 ± 7%, the same as the TM-T88IV. The current
consumption differs, depending on the print duty.
The TM-T88V does not have a low power consumption mode, which the TM-T88IV has, so
you cannot set DIP switches 2-3 and 2-4 to on. Use the newly added low power load mode
instead.
To Next Page
Loading...
