Epson TM-T88VII - Page 62

62
Chapter 3 Advanced Usage
Automatic Paper Reduction
Upper Margin
• Enable
• Disable (default setting)
Lower Margin
• Enable
• Disable (default setting)
Blank Line Spacing
• 25%
• 50%
• 75%
• Not Reduce (default setting)
Blank Space
• 25%
• 50%
• 75%
• Not Reduce (default setting)
Barcode Height
• 25%
• 50%
• 75%
• Not Reduce (default setting)
Character Height
• Inner Spacing
• Inner Spacing & Height
• Not Reduce (default setting)
• When setting the print speed to [High Speed], set the print density using Customized Value
Setting.
• Depending on print conditions, such as print duty, print head temperature, and data
transmission speed, print speed is automatically adjusted, which may cause white lines due to
intermittent print (the motor sometimes stops). To avoid this, keep the print speed constant by
setting it lower.
• By using a setting tool such as TM-T88VII Utility, the print speed can be selected from 17 levels
(from the slowest level 1 to the fastest level 17). (Default setting: level 16)
• No reduction is applied to blank dot lines that exist in a graphic data.
• Reduced barcodes are not guaranteed to be correctly scanned. Make sure to check whether
they are properly read by a barcode reader that is actually used.