63
Chapter 3 Advanced Usage
Auto Paper Feed&Cut at cover close
• Enable
• Disable (default setting)
Paper Width
• 80 mm (default setting)
• 58 mm
Top Margin
Selectable from levels 15 ~ 2 mm (0.5 mm interval)
Default setting: level 15 mm
Character/Font Settings
Default Character Code Page
Selectable from 43 pages including user defined page
Initial setting: PC437: USA, Standard Europe
Default International Character Set
Selectable from 18 sets
Initial setting: USA
Thai Character Composition
• 3 pass
• 1 pass (default setting)
• Remove all ejected paper before printing with backfeed.
• Disable the automatic top logo setting when enabling backfeed.
• You cannot use backfeed in the following cases even if you have enabled backfeed.
∗ Immediately after auto cutting while the cover is closed.
∗ While the self-test is in progress.
• If setting a top margin of 5 mm {0.2"} or less, confirm that no errors occur in your environment of
usage. Usage in a hot and humid environment or usage of paper that curls easily may increase
the risk of paper jams.
• When implementing a backfeed, rubbing smears may occur due to slack in the paper. We
recommend using thermal paper with high rub resistance.
To Next Page
Loading...
