Epson TM-T88VII - Page 65

65
Chapter 3 Advanced Usage
USB Interface Settings
Class
• Vendor Class (default setting)
• Printer Class
IEEE1284 Device ID
• Do not output IEEE1284 Device ID
• Output IEEE1284 Device ID (default setting)
USB power-saving function
• Enable
• Disable (default setting)
Interface switch waiting time
Select the number of seconds from 1 to 10 in increments of 1 second, or 60 seconds.
Default setting: 10 seconds
Main connection interface
• UIB
• Built-in USB
• Ethernet/Wi-Fi
• Auto (default setting)
• No main connection I/F
Auto Line Feed
• Always disabled (default setting)
• Always enabled
• The Class setting is applied only to the USB Type B connector.
• The USB power-saving function is valid only when the USB interface communication condition
is set to the vendor-defined class and the system configuration is set so that the USB driver can
support the USB power-saving function.
• When using this printer with multiple interfaces, make sure the interface that is always
connected to be set as the main connection.
• You cannot use wired LAN and wireless LAN at the same time.
• The displayed items vary depending on the interface configuration.
• For information about the function, see "Printing Using Multiple Interfaces" on page 28.
This is only enabled when using a serial interface. When using another interface, make settings by
using
the DIP switches.