2-2 Using the Printer
JOURNAL/SLIP FEED
When the printer is in the roll paper mode (the
SLIP
light is not on
or blinking), press the
JOURNAL/SLIP FEED
button once to advance
journal paper one line. You can also hold down
JOURNAL/SLIP
FEED
to feed journal paper continuously.
When the printer is in the slip paper mode (the
SLIP
light is on or
blinking) and slip paper is inserted, press the
JOURNAL/SLIP FEED
button once to advance slip paper one line. You can also hold down
JOURNAL/SLIP FEED
to feed slip paper continuously.
Indicator lights
The control panel lights provide information on printer conditions.
POWER
(green)
The
POWER
light is on when the printer power is on.
ERROR
(red)
The
ERROR
light is on or blinking when the printer is not ready to
print.
The
ERROR
light is on (not blinking) under the following
conditions:
❏
When the printer is first turned on or reset through the
interface. The light goes off as soon as the printer is initialized.
❏
When the printer cover is open.
❏
When the printer is at or near the end of a roll of paper.
The
ERROR
light blinks under the following conditions:
❏
When the print head is overheated. If this happens, the printer
waits until the print head cools and then resumes printing.