3-8 Troubleshooting
The cleaning procedure
During in the self test mode
1) Confirm to set a roll paper and a ribbon cassette to make use of
printer mechanism properly.
2) Turn off the power switch.
3) Open a cover(rid) of printer.
4) Turn on the power switch while turning on “JOURNAL/
SLIP FEED button.(Within TM-U925 it is expressed as “SLIP
FEED” button.)
5) Repeat releasing button and turning on that “JOURNAL/
SLIP FEED” button 3 times.
6) Close a cover (rid) of printer.
7) Following message will be printed on receipt paper and
“SLIP” LED flushes.
8) Peel off the pasteboard portion of a designated point of a
cleaning sheet.
* This procedure, 8) , only required for the case of an
adhesive cleaning sheet.
******TEST PRINT MODE*****
MICR Function Check
(1) Magnetic Ink Character reading check.
Please set personal check.
If you want to cancel check wainting status,
press SLIP FEED button.
To Next Page
Loading...
