Setting Up the Printer 1-19
Self Test
The self test lets you know if your printer is operating properly. It
checks the control circuits, printer mechanisms, print quality, ROM
version, and DIP switch settings. (It also checks the MICR reader
circuits if the printer is equipped with the optional MICR reader).
You can run the self test with either roll paper or slip paper.
Running the self test with roll paper
1. Make sure the printer is turned off and the printer cover is
closed properly.
2. While holding down the
RECEIPT FEED
button, turn on the
printer to begin the self test. The self test prints the printer
settings and status and then prints the following and pauses.
(The
RECEIPT OUT
and
JOURNAL OUT
lights blink alternately.)
Self test printing.
Please press the RECEIPT FEED button.
3. Press the
RECEIPT FEED
button to continue printing. The
printer prints a pattern using the built-in character set.
4. The self test automatically ends after printing the following:
*** completed ***
The printer is ready to receive data as soon as it completes the self
test.
Note:
If you want to pause the self test manually, press the RECEIPT
FEED button. Then press the RECEIPT FEED button again to
continue the self test.
To Next Page
Loading...
Need help?
General
Weight and Dimensions
