Reference Information 4-9
Note:
When using multi-ply paper that consists of an original and three
copies, be sure to print with a 9
×
9 font. If a 7
×
9 font is used, some
characters on some of the copies may not be readable.
Notes on slip paper
❏
The slip paper must be flat, without curls or wrinkles,
especially at the top edges. Otherwise, the paper may rub
against the ribbon and become dirty.
❏
There must be no glue on the bottom edge of slip paper. It is
desirable for the glue to be on the top edge. Choose slip paper
carefully when the glue is on the right or left edge, since paper
feeding and insertion are affected by gluing conditions (e.g.,
glue quality, method, and length) and glue location. (See the
illustration below.) Be especially careful when slip paper is
wide and has the glue on the right or left edge, since it may not
feed in a straight line.
.
❏
Since the slip insertion detector uses a photo detector, paper
that has holes at the detector position, or is translucent, must
not be used. (See the illustration below.)
Total
thickness:
0.24 mm (.0094") or less
(original to original + 3
copies)
0.30 mm (.0118") or less
(original + 4 copies)
Paper feed direction
OK to use Do not use Use carefully Use carefully
Glued area
To Next Page
Loading...
Need help?
General
Weight and Dimensions
