Menu Settings and Explanations
Common
Settings
Paper Size Select the paper size.
Paper Type Select the paper type.
Orientation Select the printing direction.
Quality Select the print quality.
Ink Save Mode Conserves ink by reducing the print density.
Print Order Last Page on Top: Prints from the rst page of a le.
First Page on Top: Prints from the last page of a le.
Number of
Copies
Set the number of copies.
Binding Margin Select the binding position.
Auto Paper
Ejection
Ejects paper automatically when printing is stopped during a print job.
2-Sided Printing Performs 2-sided printing.
PCL Menu Font Source Resident: Select to use a preinstalled font on the printer.
Download: Select to use a font you have downloaded.
Font Number Select the default font number for the default font source. The available number
varies depending on the settings you made.
Pitch Set the default font pitch if the font is scalable and of xed-pitch. You can select from
0.44 to 99.99 cpi (characters per inch), in 0.01 increments.
This item may not appear depending on the font source or font number settings.
Height Set the default font height if the font is scalable and proportional. You can select
from 4.00 to 999.75 points, in 0.25 increments.
This item may not appear depending on the font source or font number settings.
Symbol Set Select the default symbol set. If the font that you selected in the font source and the
font number setting is not available in the new symbol set setting, the font source
and the font number settings are automatically replaced with the default value, IBM-
US.
Form Set the number of lines for the selected paper size and orientation. This also causes a
line spacing (VMI) change, and the new VMI value is stored in the printer. This means
that later changes in the page size or orientation settings cause changes in the Form
value based on the stored VMI.
CR Function Select the line feed command when printing with a driver from a specic operating
system.
LF Function
Paper Source
Assign
Set the assignment for the paper source select command. When 4 selected, the
commands are set as compatible with the HP LaserJet 4. When 4K is selected, the
commands are set as compatible with the HP LaserJet 4000, 5000, and 8000. When
5S is selected, the commands are set as compatible with the HP LaserJet 5S.
User's Guide
Printer Basics
24
To Next Page
Loading...
Need help?
General
