360
Code Condition/solution
109 The received fax was already deleted.
110 The job was printed 1-sided because the loaded paper does not support 2-sided printing.
111 Available memory is running low. Reduce the size of the print job.
120 Cannot communicate with a server using an open platform. Check the server or network
for errors.
201 The product's memory is full. You can send pages individually, or print received faxes and
delete them to free up memory space.
202 The line was disconnected by the recipient's fax machine. Wait a moment, then try again.
203 The product cannot detect a dial tone.
Make sure the phone cable is connected correctly and the phone line works. If you
connected the product to a PBX (Private Branch Exchange) phone line or Terminal
Adapter, change the Line Type setting to PBX. If you still cannot send a fax, turn off the
Dial Tone Detection setting. (Turning off the Dial Tone Detection setting may cause the
product to drop the first digit of a fax number.)
204 The recipient's fax machine is busy. Wait a moment, then try again.
205 The recipient's fax machine does not answer. Wait a moment, then try again.
206 The phone cable is incorrectly connected to the product's LINE and EXT ports. Connect
the phone cable correctly.
207 The phone cable is not connected. Connect the phone cable.
208 The fax could not be sent to some of the specified recipients.
Print a fax log to check which recipients failed to receive the fax. If the Save Failure Data
setting is turned on, you can resend a fax from Job Status in the Job/Status menu.
301
401
There is not enough storage space available to save the data in the external memory
device. Clear space on the device or use a different device.
302
402
The external memory device is write-protected. Disable write protection.
303 No folder is available for saving the scanned file. Create a folder or use a different
memory device.
To Next Page
Loading...
Need help?
General
