7. Select Advanced.
Select a connection method from the following
❏ “Ethernet Cable” on page 49
❏ “WPS-PIN” on page 54
❏ “WPS-PBC” on page 55
❏ “Operator Panel” on page 57
❏ “EpsonNet Config” on page 58
Ethernet Cable
1. Select Ethernet Cable, and then click Next.
2. Follow the on-screen instructions, and then click Next.
The Printer Setup Utility screen appears.
3. Select the printer to be configured in the Select Printer screen, and then click Next.
Note:
If the printer to be configured is not listed in the Select Printer screen, try the following steps:
AL-M200 Series User’s Guide
Printer Connection and Software Installation 49
To Next Page
Loading...
