Epson XP-8700 Series

Restore Default Settings
Restore all Wi-Fi Direct (simple AP) settings to their defaults.
e
Wi-Fi Direct (simple AP) connection information of the smart device saved to the printer is deleted.
Changing the Connection from Wi-Fi to USB
Follow the steps below if the Wi-Fi you are using is unstable, or if you want to change to a more stable USB
connection.
1.
Connect the printer to a computer using a USB cable.
2.
Select a printer that is not labeled (Network) when printing using a USB connection.
Related Information
& “Part Names and Functions” on page 18
Setting a Static IP Address for the Printer
is
section describes how to make settings from the printer's control panel.
1.
Select Settings on the printer's home screen.
2.
Select Network Settings > Advanced > TCP/IP.
3.
Select Obtain IP Address, and then select Manual.
4.
Enter the IP address.
Focus moves to the forward segment or the back segment separated by a period if you select
l and r .
Conrm the value reected on the previous screen.
5.
Set up the Subnet Mask and Default Gateway.
Conrm the value reected on the previous screen.
c
Important:
If the combination of the IP Address, Subnet Mask and Default Gateway is incorrect, you cannot proceed with
the settings. Conrm that there is no error in the entry.
In These Situations > Re-Setting the Network Connection > Setting a Static IP Address for the Printer
125