❏ Compared to printing on genuine Epson paper, the print density is lowered to prevent ink from smearing on the
CD/DVD. Adjust the print density as necessary.
❏ Allow the printed CD/DVDs at least 24 hours to dry avoiding direct sunlight. Do not stack or insert the CD/
DVDs into your device until they are completely dry.
❏ If the printed surface is sticky even aer it has dried, lower the print density.
❏ Reprinting on the same CD/DVD may not improve the print quality.
❏ If the CD/DVD tray or the internal transparent compartment are accidentally printed on, immediately wipe o
the ink.
❏ Depending on the print area setting, the CD/DVD or CD/DVD tray may get dirty. Make settings to print on the
printable area.
❏ You can set the print range for the CD/DVD to a minimum of 18 mm for the inner diameter, and a maximum
of 120 mm for the outer diameter. Depending on the settings, the CD/DVD or tray may be smeared. Set within
the print range for the CD/DVD you want to print.
Loading and Removing a CD/DVD
When printing on or copying a CD/DVD, instructions are displayed on the control panel informing you when to
load the CD/DVD. Follow the on-screen instructions.
Related Information
& “Printing Photos onto a CD/DVD Label” on page 70
& “Copying on a CD/DVD Label” on page 83
Loading Papers and CD/DVDs
>
Loading a CD/DVD
>
Loading and Removing a CD/DVD
43
To Next Page
Loading...
