Essilor E-Tess Tracer
3- Check Pro 2
2
4. After a few seconds, the information is displayed on screen,
5. To exit the screen and return to the previous screen, click on .
Self-test
1. Click on: ,
2. Choose the type of test you want to perform:
- Selection of line 1: the self-test will automatically run the 5 tests in the table one after the
other,
- Selection of a line in frame 2: the corresponding unit test is performed.
3. To validate the choice and start the test, click on
,
4. At the end of each test, the result is displayed:
: Test NOK, contact your technician. The code and description will be written in zone 3,
: Test OK, you can continue using your tracer.
5. Click on to exit the screen.
2
To Next Page
