Essilor e-Tess - Page 23

Essilor E-Tess Tracer
23 3- Check Pro


 Calibration check
2. Click on: ,
3. Choose the number of the frame "standard gauge" displayed, corresponding to the gauge to be used,
4. Position the frame "standard gauge" in e-Tess, stable on the four lower studs, with the "V" open
upwards,
5. Click on to validate,
: is displayed in the Check Pro window,
6. Check the gauge number on the e-Tess display,
7. Press  on e-Tess to start tracing,
8. The check is carried out. At the end, there are two possibilities:
: The check is not OK, a window displays the error message code,
Number of the frame standard
gauge.