◦ Back to the main edging screen
◦ Start the edging cycle
15. High-base bevel screen “automatic trajectory”
In this screen, the trajectory on the lens section cannot be configured: it is calculated automatically. This
calculation harmonises as best as possible, the lens base, the base of the frame and the shape.
b. High-base beveling
Call up the desired shape located on the tracer or on the job management program.
The shape is displayed on the edger work screen.
After the tracing of a high-base frame:
• The high-base finish is selected by default.
• The customized mode is selected by default.
In high-base finish, you cannot polish your bevel. However, the high-base wheel has been
designed to provide an equivalent finish on polycarbonate lenses.
Select lens material.
Select the type of cycle.
Choose to create or not to create a small or a large chamfer on the rear surface of the lens.
For more information, consult the section Edging a lens > Perform a polishing (F p.65) and Edging a
lens > Perform a chamfering (F p.66).
Press the “cycle start” button (front face) or .
The door closes, the lens is clamped and then felt.
The high-base bevel finish screen “automatic trajectory” is displayed by default.
To Next Page
Loading...
