1. Chamfer
◦ Small, front surface
◦ Large, front surface
◦ Small, rear surface
◦ Large, rear surface
2. Lens materials
◦ Plastic
◦ Polycarbonate
◦ MHI
◦ Trivex
TM
◦ Tribrid
TM
◦ Glass (not available)
3. Increasing or reducing the default chamfer
a. Press the value to be modified.
> The numeric keypad is displayed.
b. Enter the new value.
◦ Negative value: the chamfer will be smaller
◦ Positive value: the chamfer will be larger
c. Press to confirm.
Once the modification is made, press to return to the work screen.
e. Adjusting the groove
After edging a lens, if the width or depth of the groove always seem too close too small or too big, you can
adjust them.
To access that menu from your edger work screen, select > > .
The following screen is displayed:
To Next Page
