The wheel is installed.
During the installation of a new tool, the statistics are automatically reset to zero by default.
>The icon appears by default at the bottom of the screen.
Press at the bottom of the screen to confirm the tool change-over.
The module goes back into its initial position, the statistics are cleared.
d. Changing the chamfering wheel
We recommend that you change the chamfering wheel every 6,000 chamfers.
From the work screen of your edger, select > > to change the chamfering wheel.
Prerequisite:
You must have the following tools:
• Blocking key
• an Allen key
Press .
The GMD module moves to facilitate the operation.
Press to receive more image information on the tool assembly/dismantling procedure.
To Next Page
Loading...
