At least one of the spindles has reached 100% wear and must be replaced immediately.
The icon appears beside the small maintenance access button and flashes: press above to directly
access the preventive maintenance menu of the “small tools” module:
The bargraph flashes and the icon appears on the spindle that needs to be replaced.
A red key appears on the finishing icons linked to the module functions:
• Milling
• Drilling
• Grooving
• Chamfering (small chamfer)
• Chamfering (large chamfer)
4. CHANGING OR CLEANING THE EDGER TOOLS
This menu lets you change the edger’s “small tools” module:
• to replace them with tools of a different diameter (drill bits) or clean them (mill bit and drill bit),
• to replace them with new tools,
You can replace:
• The drill bit
• The mill bit
• Step bevel wheel
To Next Page
Loading...
