Extended period of non-use
For a prolonged period of non-use (a few days), it is preferable to turn off the edger using the main
switch.
It must be powered off at least once a week.
c. Using the touch screen and keypads
Using the touch screen
Use the stylus supplied with the machine to use with the touch screen.
You can also touch the screen with your finger.
• If the screen is not sensitive enough to finger pressure, press lightly with a fingernail.
• If the response area does not correspond to the position of the key, you need to calibrate the touch
screen. For further information, refer to the section Maintenance and servicing > Check and calibrate
> Calibrate the touch screen (F p.83).
• Never press hard on the screen as this could break it.
• Never press on the screen with sharp objects such as pens, scissors, clamps, etc.
• Screen breakage is not covered by the guarantee.
On the screen, press the icon buttons to access the desired menus and job functions .
Using the keypads
When you need to enter or modify data, two types of keypads are automatically displayed, according to the
information to be entered.
• The numeric keypad is displayed for entering values.
• Reset the fields
• Go back
• Confirm
• Cancel and go back to the work screen
• The alphanumeric keypad is displayed to save or search for jobs.
To Next Page
Loading...
Need help?
General
