• automatic, you do not have to configure anything, all the data is automatically recovered from
the tracer. The lens edging starts automatically after the feeling cycle.
• customized, the finish parameters can be fully customized.
For further information, refer to the section concerning your type of finish.
The different lens edging stages appear on the screen.
2. PERFORM A BEVELING
This section describes the procedures for the creation of a bevel:
• In automatic mode (F p.21), you do not have to configure anything. All the data is automatically
retrieved from the tracer. The lens edging starts automatically after the feeling cycle.
• In customized mode (F p.24), you can opt for front/rear surface tracking, a distributed bevel,
lens curve tracking or frame rim tracking. You can also do the following:
◦ a general modification of the bevel curve (F p.26)
◦ a modification at a point of the bevel curve (F p.27)
◦ a displacement of the bevel curve (F p.28)
• You can consult the description of the customized bevel screen (F p.23).
a. Automatic beveling
Call up the desired shape located on the tracer or on the job management program.
The shape is displayed on the edger work screen.
After the tracing of a rimmed frame:
• The bevel finish is selected by default.
• The automatic mode is selected by default.
If you want to produce a bevel less than 0.75mm high, configure the bevel directly on the
screen.
To Next Page
Loading...
Need help?
General
