1. Adjusting the default groove width
◦ Press to reduce the width of the groove.
◦ Press to increase the width of the groove.
2. Adjusting the default groove depth
◦ Press to reduce the depth of the groove.
◦ Press to increase the depth of the groove.
Once the modification is made, press to return to the work screen.
f. Adjust the position of high-base bevel
After lens edging, if the position of high-base bevels seems consistently too far ahead or too far behind, you
can adjust it.
To access this menu from your edger work screen, select > > .
The following screen is displayed:
To Next Page
Loading...
