The edger calculates the shelf bevel value to be applied between each of the four or eight points of
each area.
The bevel trajectory on the rear surface is modified in the work screen. The result can be viewed in
the zoom window.
Press the buttons and on the right of your screen to modify the width of the flat side of the bevel.
The result can be viewed in the zoom window.
Press the and buttons on the right of your screen to modify the front surface tracking value.
The result can be viewed in the zoom window and in the window showing the bevel trajectory on the
lens section.
Press to perform a back chamfer of the assembly aid.
To Next Page
Loading...
