Choose whether or not to polish the lens.
You cannot do a chamfer on a mixed job.
For more information on polishing, refer to the section Edging a lens > Polishing (F p.65).
Press .
The door closes, the lens is clamped and then felt.
The mixed finish screen is displayed:
The default setting is the bevel - groove finish in automatic mode.
Customizing the mixed finish
Select the desired type of mixed finish.
Press to access the area definition screen.
The area definition screen is displayed on a 1:1 scale. You can thus refer to a sample lens placed on
the screen.
Select the finish you want in area 1, then area 2.
Press the button to unlock an area delimitation point.
Press the and buttons to move the unlocked point.
Press to move the delimitation points directly on the touch screen. The two points are then
unlocked. Drag them with the stylus.
If necessary, press to modify the position of the center of the groove or bevel using the buttons
and .
This value cannot be modified in automatic mode.
To Next Page
Loading...
