Unison Station User Manual 13
To select a Preset
1. Press the desired Preset button
. The button recalls the set of light zone
intensities recorded to its Preset. The button’s LED illuminates when the
Preset is active.
To temporarily adjust Preset zone levels
1. Slide that zone’s fader up or down
until its position matches the current
lighting level. As it matches the zone level, the fader takes control from
the Preset. The fader LED illuminates and the Preset LED turns off.
2. Adjust zone intensity with the fader. To make the new levels permanent,
record them to a Preset.
To temporarily adjust (master) all Preset levels
1. Slide the Master fader all the way up
. When it reaches the top of the slot,
the Master fader activates and its LED illuminates.
2. Adjust intensities with the Master fader. To make the new levels
permanent, record them to a Preset.
To Next Page
Loading...
