ETC Unison - To Take a Snapshot from a DMX512 Device

Unison Station User Manual 19
To take a “snapshot” from a DMX512 lighting control device
1. Set light zone zone intensities
to create the desired lighting look using a
DMX512 lighting control device connected to the DMX512 connector
station.
2. Touch the [Record] button. Record appears over the button, indicating the
station is in Record mode. (Record mode deactivates after seven
seconds.)
3. Touch the desired Preset button. Current light zone intensities are
recorded to the button’s Preset, replacing previously recorded Preset
intensities. The button is highlighted when recording is complete.