Eternus DX60 - Serverview (SNMP Trap Notification) Setup

To Next Page

To Previous Page

Chapter 7 Setup

> 7.4 Monitoring Setup

ETERNUS DX60/DX80/DX90 Disk storage system User Guide

174

P3AM-3042-07ENZ0

8 Click the [Send Test E-mail] button to check that an E-mail can be sent to the

specified E-mail destination address.

Figure 7.36 Send Test E-mail

End of procedure

7.4.3 ServerView (SNMP Trap Notification) Setup

This section explains how to perform settings to monitor event notification (Trap) by SNMP using

the "ServerView" server monitoring tool.

For details on server settings, refer to the manual that is provided with ServerView.

Also, for events that are detected by ServerView when monitoring the device, refer to "Appendix

B Events detected by ServerView" (page 231).

Procedure

1 Set the network environment of the ETERNUS DX60/DX80/DX90.

When the ETERNUS DX60/DX80/DX90 and ServerView management device are in differ-

ent subnet environments, set the Gateway IP address and destination network address in

the [Setup Network Environment] screen of GUI.

1-1 Start GUI.

1-2 Click [Setup Network Environment] under the [Network Settings] menu on the [Global

Settings] tab in the GUI screen.

The [Setup Network Environment] screen appears.

Refer

Manual provided with ServerView