EasyManua.ls Logo

Eton VECTOR ST 250 - FRONT WHEELS

Eton VECTOR ST 250
154 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
122
14.2 TROUBLESHOOTING
HARD STEERING
FRONT WHEEL WOBBLING
BRAKE DRAG
STEERS TO ONE SIDE
POOR BRAKE PERFORMANCE
★ Faulty tire
★ Insufficient tire pressure
★ Faulty tire
★ Worn front brake drum bearing
★ Bent rim
★ Axle nut not tightened properly
★ Incorrect brake adjustment
★ Sticking brake cable
★ Bent tie rods
★ Wheel installed incorrectly
★ Unequal tire pressure
★ Incorrect wheel alignment
★ Brake shoes worn
★ Worn brake drum
★ Brake linings oily, greasy or dirty
★ Improper brake adjustment
14.3 FRONT WHEELS
REMOVAL
(The disassemble of front wheel system
in this serials are the same)
Raise the front wheels off the ground by placing a jack
or other support under the frame.
Remove the front wheel nuts, washer and wheels.
INSTALLATION
Install and tighten the four-wheel nuts
Torque: 24 N.m (17.7 lbf.ft)
Remember put a cotter pin in the castle nut.
Wheel nuts

Table of Contents