EasyManua.ls Logo

Eton VECTOR ST 250 - ELECTRIC STARTER

Eton VECTOR ST 250
154 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
144
CHARGING
Firstly, connect the charged positive cable to the battery
positive terminal. Secondly, connect the charged negative cable to the battery
negative terminal.
Using 0.9A-charging current about 11 hours. (Normal charging)
Or using 4A-charging current about 3 hour. (Quick charging)
Keep flames and sparks away from a battery being charged.
Quick charging should be limited to an emergency;
Normal charging is preferred.
17.5 ELECTRIC STARTER
Information
If a battery has not work a period of time, the voltage may
reduce and may not provide enough power to starter motor.
If a battery is in a good condition, but engine can not be start.
Please go back to service.
TROUBLESHOOTING
Starter Motor Turns Slowly
Weak battery.
Poorly connected starter motor cable.
Failed starter motor.
Poorly connected battery ground cable.
Starter Motor Cannot Work
Engine stop switch at “off “position.
Gearshift bar is not at neutral position.
Check for a blown fuse near battery.
Make sure that the battery is fully charged and in good condition.
17.6 LIGHT BULBS REPLACEMENT
HEADLIGHT
To remove the headlight, please loosen three screws at
back of the headlight.
Head light

Table of Contents

Related product manuals