EasyManua.ls Logo

Eton VECTOR ST 250 - HANDLEBAR

Eton VECTOR ST 250
154 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
115
13.2 TROUBLESHOOTING
HARD STEERING
FRONT WHEEL WOBBLING
STEERS TO ONE SIDE
FRONT SUSPENSION NOISE
HARD SUSPENSION
SOFT SUSPENSION
Faulty tire
Steering shaft holder too tight
Insufficient tire pressure
Faulty steering shaft bushing
Damaged steering shaft bushing
Faulty tire
Worn front brake drum bearing
Bent rim
Axle nut not tightened properly
Bent tie rods
Wheel installed incorrectly
Unequal tire pressure
Bent frame
Worn swing arm pivot bushings
Incorrect wheel alignment
Loose front suspension fasteners
Binding suspension link
Faulty front swing arm bushings
Improperly installed front swing arms
Bent front shock absorber swing rod
Weak front shock absorber springs
Worn or damage front swing arm bushings
13.3 HANDLEBAR
REMOVAL
Remove the throttle housing by
two fixed screws.
Remove the throttle lever housing on the right
side handle bar.
Remove brake lever bracket assembly.
Screws

Table of Contents

Related product manuals